Management of electrik screw driver
●Torque Meter DI
DI-9 series is most suitable for checking and controlling the torque of
Electric Screwdriver and Torque Driver.
The conventional function remains as it is. Further
(1) High and low limits judging function .
(2) The maximum, the minimum, and the average can be checked.
New function
1. High and low limits judging function. A setup is possible respectively in a maximum
value and a minimum value. GOOD/NG is checked with an LED lamp
(GOOD) 
(NG) 2. Display and Preservation of Maximum, Minimum Value, and Average
Measurement by the side of rewinding (CCW) can be performed.
□ Save 300 data.
□ A convenient functional setup of a setup of a measurement start value etc.
□ About the load torque under measurement, it is a data output at real time
(every about 1 / 100 seconds)
The best for everyday check of an electric driver
Wide measurement range (0 - 8000digit),
it corresponds to various set torques
Can measure without inversion/
rolling-back work efficiently by OW joint (PAT.P).
The conventional main functions
□ Rechargeable battery drive
□ By the auto power OFF, it forgets to erase and prevent.
□ By the RS
□ One-touch zero adjustment
□ Measured-value display automatic clear setup
性能參數(shù)
|
Specification |
DI |
DI |
|
Measuring range |
0.030-8 N?m |
3.0-800 mN?m |
|
0.30～80 kgf?cm |
0.030～8 kgf?cm |
|
|
0.30～70 lbf?in |
0.030～7 lbf?in |
|
|
Accuracy |
±0.5% (499 digit or less ±3digit) |
|
|
Display |
The 4 figures digital display of LCD |
|
|
The measurement direction |
CW-CCW (right and left) |
|
|
Zero return by one touch |
Return to zero by pressing clear button. |
|
|
Measurement Mode |
Track,/Peak/Peak-Down |
|
|
High and low limits judging function |
High and low value are measurement within the limits, and can be set up. |
|
|
Real-time Output |
Load torque value is outputted every about1/ 100 second by RS |
|
|
The Maximum, the minimum, and the average value display |
The maximum, the minimum, average value, and the data number of 30 data are displayed.It saves to ten channels. |
|
|
Data transfer |
Serial interface RS |
|
|
Auto power save |
10 minutes no use, automatically switch off. |
|
|
Power supply |
Ni-Cd chargeable battery 1.2V × 5cells 700mAh |
|
|
Charging time |
From empty - Less than 6hours |
|
|
Continuous working time |
About 12hours |
|
|
clearance |
It is a display clearance in set-up time. (0.1 - 3.0 sec) |
|
|
Socket size |
□ 20mm/ □9.5mm |
|
|
Dimension / Weight |
W:155×D:125×H:55 / About |
|
|
Recommend buffer accessories |
Measuring joint |
Measuring joint |
|
Cube (with a 5th page screw hole) 20x20x20 |
||
|
AC/DC adaptor (Please choose AC adaptor out of 120V, and 230V.) |
||
|
Exclusive receipt case |
||
|
An inspection report, a proofreading certificate, a traceability system figure |
||
