Specification

DSD-4M

Measuring range
(at the time of Track)

0.030 - 4 N-m

0.30～40 kgf-cm

0.30～35 lbf-in

*A measurement unit is fixed to one unit. Specify units when ordering

Accuracy

± 0.5% (in case of reading 499 or less = last digit +/- 3 reading)

Measuring unit

lbf?in-kgf?cm-N?m

Display

The 4 figures digital display of LCD

The measurement direction

CW-CCW (right and left)

Measuring
mode

P-P  Peak

Holding Peak Load Value

T-R  Track

Showing Real time torque value ( Used for Zero-Adjustment )

P-D  Peak down

Holding Load Value at the moment to change from upward to downword

C Real-time output

Load torque value is outputted every about1/ 70 second by RS232C.

Decision
function

Setting of torque value

Programmable High and Low setpoints with both audible beep and Green/Red LED indicator for uniform torque tightening or GO/NO GO testing

The Maximum, the minimum, and the average value

Displays, memory and output the data number, the maximum, the minimum, and the average value of the measured value to 30 data. It can save by a maximum of 10 channels.

Data spec.

Data transfer

Serial interface RS232C (Baud rate : 9600)

Data memory

300 data / ten channels data

A setup of the number of counts

One to 99 count   (count in a direction with a bundle)

Power supply

Ni-Cd chargeable battery 1.2V×4cells 600mAh

Auto power save

10 minutes no use, automatically switch off.

Charging time

From empty - less than 5hours

Continues working time

12 hours

Bit fit mouth

HEX6.35

Weight

330g

Attachment

Bit （＋）?。＃薄。＃?

Accessories
 (one piece each)

Dedicated AC/DC Adaptor (Charger), 230VAC or 120VAC- DC 7.5V 120mA Output

An inspection report, a proofreading certificate, a traceability system figure