AEV300-AC007D-EU 7kw AC charging pile
1.Reference standard
EN IEC 61851-1:2019 Electric vehicle conductive charging system - Part 1: General requirements
IEC 60364-4-43:2008 LOW-VOLTAGE ELECTRICAL INSTALLATIONS - PART 4-43 : PROTECTION FOR SAFETY - PROTECTION AGAINST OVERCURRENT
IEC 61851-21-2:2018 Electric vehicle conductive charging system – Part 21-2: Electric vehicle requirements for conductive connection to an AC/DC supply – EMC requirements for off-board electric vehicle charging systems
IEC 61000-6-1:2016 Electromagnetic compatibility (EMC) – Part 6-1: Generic standards –Immunity standard for residential, commercial and light-industrial environments
IEC 61000-6-2:2016 Electromagnetic compatibility (EMC) – Part 6-2: Generic
standards –Immunity standard for industrial environments
IEC 61000-6-3:2006 Electromagnetic compatibility (EMC) – Part 6-3: Generic standards –Emission standard for residential, commercial and light-industrial environments
IEC 61000-6-4:2006 Electromagnetic compatibility (EMC) – Part 6-4: Generic
standards –Emission standard for industrial environments
|
Product
specific
ations
|
Input voltage
|
AC230V
|
|
Input mode
|
Single-pha
se
three-wire
system
|
|
Operating
frequency
|
50Hz/60Hz
|
|
Output voltage
|
AC230V
|
|
Output current
|
0A～32A
|
|
Output interface
|
Single shot
|
|
The length of the AC charging cable
|
5 meters
|
|
Ingress protection
|
IP54
|
|
Material
|
PC/ABS
|
|
Operating ambient temperature
|
-30℃
-55℃
|
|
Protection features
|
Lightning protection, overload protection, short circuit
protection, leakage protection (optional)
|
|
Methods of Communication
|
4G
/WiFi/Ether
net/Bluetoot
h
|
|
display
|
A 4.3-inch display is available as an option
|
5.Installation requirements
5.1Power supply
The power supply mode of AC charging pile is AC single-phase power supply,input electrical requirements:
??AC operating coltage:1P/N/PE 230V
??AC operating frequency:50Hz/60Hz
5.2Environment requirements
??Working environment temperature：-30℃~50℃
??Relative humidity：5%~95%
??Installation vertical inclination：≤5%
??Altitude of installation and operation：≤2000m
??There is no strong vibration and impact,no strong electromagnetic interference
4.3 Installation steps
1. According to the size of the mounting plate, make four holes in the wall with a diameter of 4mm and a depth of 20mm；
2. Insert the plastic expansion tube into the hole；
3. Secure the mounting plate to the wall using expansion screws (M4X20)
4. After sliding the EVSE into the mounting plate from top to bottom, fix the EVSE with M4X12 screws from the side
